LPV2-10 is a LiPo pack voltmeter that measures each cell separately and displays either all the cell voltages together ( 0.01V resolution) or each individual cell's voltage with 0.01V resolution.
SUITABLE ONLY FOR LITHIUM POLYMER BATTERY PACKS
It derrives it's power from the first 2 cells in a pack drawing a very low current.
The minimum pack that can be measured is a 2 cell pack (2S) and the maximum is a 10 cell pack (10S) depending on the LPV2-10 version.
LPV2-XX is version for up to XXcells so LPV2-10 is for 10 cells

Operation is very simple .
When connected to the LiPo pack the LPV2-10 continuously collects the voltage readings from the cells in the pack and displays them all together for two seconds with a resolution of 1/10 volt and then starts displaying in sequence the individual cell voltages with a resolution of 1/100 volt along with informative description of the cell status.After the last individual cell is displayed the procedure starts all over again until it is disconnected from the battery pack.

In case the LPV2-10 is connected to a less cell count pack than the maximum it can display(depending on version) then the cells that do not exist display as 0.00 and the comment is "NO CELL PRESENT".

The lowest voltage that can be measured accurately for each LiPo cell is apx. 2.5V which is well below the low voltage limit and the highest is 4.95V which is also well above the safe high voltage limit of LiPo cells.

All versions can be upgraded by us to a higher version (up to LPV2-10).
The connector for the pack is not inluded as this varies with pack manufacturer and should be installed by user.
The LPV2-XX terminates with plain wires of different colour and associated explanatory instruction diagram.